Battery - BYD S1 EV User Manual

Power battery recycling
When a new energy car meets the scrapping requirements, it should be scrapped in the
steps as follows:
1. Take the car to BYD recycling outlet, to evaluate the residual value of the power

battery.

2. Take the evaluated car to the scrapped car recycling and dismantling plant to
disassemble the power battery.
3. Transfer the used power battery removed at the car recycling and disassembly plant to
the service outlet for its repurchase.
Warning
●
New energy car owners have the responsibility and obligation to hand over the used
power batteries to the recycling service outlet. If the used power battery is handed
over to other organizations or individuals for disassembly and dismantling, the
resulted environmental pollution or safety accident shall be borne by the users.

Battery

■
Check the conditions of the power battery once a month. Check the terminals for
corrosion.
■
If there is some corrosion on the terminals, must apply a soda solution onto the
surface of the terminals, where some bubbles will be generated and the soda solution
will be gradually turned into brown. After the bubbles are no longer emitted, wash the
terminals with clean water and wipe them with a cloth. Finally, apply the grease onto
the surfaces of the terminals to prevent corrosion.
■
If the connector is loosened, tighten the nut on the clamp to a certain tightening torque.
Tighten the pressing device to hold the battery in place. If the pressing device is
tightened excessively, it will damage the battery box.
Tip
●
If the battery electrolyte is insufficient, must replace the battery; do not add the
electrolyte without permission.
●
If you leave the car, must close the doors and turn off all electrical devices.
●
If the car is placed for a long time, please disconnect the negative battery cable.
4-2 Battery 119
4