Contents Of The Antenna Kit; Safety Warnings - Cisco ANT-4G-PNL-OUT-N Manual

Chapter 6 Cisco Multiband Panel Outdoor 4G MIMO Antenna (ANT-4G-PNL-OUT-N)

Contents of the Antenna Kit

The antenna kit contains:
•
•

Safety Warnings

Warning Avoid using or servicing any equipment that has outdoor connections during an electrical storm.
There may be a risk of electric shock from lightning. Statement 1088
Warning Do not work on the system, or connect or disconnect cables, during periods of lightning activity.
Statement 1001
Do not locate the outdoor antenna near overhead power lines or other electric light or power
Warning
circuits, or where it can come into contact with such circuits. When installing the antenna, take
extreme care not to come into contact with such circuits, as they may cause serious injury or
death. For proper installation and grounding of the antenna, please refer to national and local
codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada:Canadian
Electrical Code, Section 54). Statement 1052
This equipment must be grounded. Never defeat the ground conductor or operate the equipment
Warning
in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1024
Warning Only trained and qualified personnel should be allowed to install, replace, or service this
equipment. Statement 1030
Warning To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. Use the statement number provided at
the end of each warning to locate its translation in the translated safety warnings that
accompanied this device. Statement 1071. SAVE THESE INSTRUCTIONS.
1 x Cisco ANT-4G-PNL-OUT-N antenna
1 x mounting bracket
Cisco CGR 1000 and 2000 Series Connected Grid Antennas Guide
Installing the Antenna
6-19