Table of Contents
Advertisement
Site Selection
Before attempting to install your antenna, determine where you can best place the antenna for safety and
performance.
Follow these steps to determine a safe distance from wires, power lines, and trees.
Measure the height of your antenna.
Step 1
Add this length to the length of your tower or mast and then double this total for the minimum
Step 2
recommended safe distance.
If you are unable to maintain this safe distance, stop and get professional help.
Caution
Generally, the higher an antenna is above the ground, the better it performs. Good practice is to install
your antenna about 5 to 10 ft (1.5 to 3 m) above the roof line and away from all power lines and
obstructions. If possible, find a mounting place directly above your wireless device so that the lead-in
cable can be as short as possible.
Installing the Antenna
You can install the antenna on any flat vertical surface. Hardware for mounting the antenna on drywall
is provided. If you intend to install your antenna on another surface, you must provide the appropriate
hardware.
Note
Four mounting screws are provided to mount the antenna . To ensure a safe, reliable, and long-standing
installation, you must use all four screws to mount the antenna.
Tools and Equipment Required
A mounting installation kit is shipped with the antenna and consists of the following hardware:
•
•
•
You need the following tools and equipment, which are not provided.
•
•
•
•
•
78-16941-02
Four #8 x ¾ screws
Four #8 plastic anchors
Four end caps
A Phillips screwdriver
A drill
A #29 ((0.136-in (3.45 mm)) drill bit (For drywall installation, other surfaces may require a different
size)
A pencil
A small mallet or hammer
Cisco Aironet 8.5-dBi Patch Antenna (AIR-ANT2485P-R)
Installing the Antenna
5
Advertisement
Table of Contents
