Pro-Form 850 User Manual page 12

13. Apply a coat of grease to one of the Pedal Arm
Axles (32) and to the two Pedal Arm Bushings
(33) in the Left Pedal Arm (14).
Next, slide an M8 Washer (88) and a Pedal Arm
Cover (31) onto an M8 x 23mm Shoulder Screw
(115), and turn the Shoulder Screw a few turns
into the Pedal Arm Axle (32).
While another person holds the front end of the
Left Pedal Arm (14) inside the bracket on the
Left Upper Body Leg (11), insert the Pedal Arm
Axle (32) into both parts.
Next, slide an M8 Washer (88) and a Pedal Arm
Cover (31) onto another M8 x 23mm Shoulder
Screw (115), and turn the Shoulder Screw a few
turns into the Pedal Arm Axle (32). Tighten both
Shoulder Screws.
Repeat this step on the other side of the
elliptical.
14. Lift the latch on the underside of the Left Pedal
Arm (14), and set the Left Pedal Arm on the left
Crank Bushing Sleeve (43).
Release the lever, and make sure that the Left
Pedal Arm (14) is securely connected to the
Crank Bushing Sleeve (43).
Connect the Right Pedal Arm (not shown) in
the same way.
See step 5. Tighten the M8 x 69mm Button Bolt
(80) and the two M8 x 23mm Button Screws
(84).
15. Make sure that all parts of the elliptical are properly tightened. Note: Some hardware may be left over
after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical.
13
11
88
31
31
88
115
Grease
32
14
14
Latch
12
12
115
33–Grease
14
43