Troubleshooting - ADC Advantage 2200 Directions For Use Manual

Detailed Description of Product Functions
1. Display Type: LED
2. SpO :
2
Measurement
range:
Accuracy:
3. Pulse Rate:
Measure range: 30bpm~250bpm
Accuracy:
Pulse Intensity: Bar Graph Indicator
4. Power Requirements:
Two (2) AAA alkaline Batteries
Power consumption:
Less than 40mA
Problems Possible reason(s)
SpO or 1. Finger is not inserted
2
pulse rate
cannot be
2. Oxyhemoglobin value is too
shown
normally
SpO or 1. Finger might not be inserted
2
pulse rate is
2. Excessive movement during
shown
unstably
1. Low battery strength
The Oximeter
2. Batteries installed incorrectly
cannot be
3. The Oximeter might be damaged
powered on
1. The product is automatically
Display
suddenly
powers off.
2. Low battery strength
"Error7"
1. Low power
2. Oximeter is damaged
70-100%
70%-100%, ±2%;
69% no definition.
30~99BPM, ±2BPM;
100bpm~250bpm

Troubleshooting

correctly
low to be measured
deep enough
measurement
powered off when no signal is
detected for longer than 8 seconds
Low power indication:
Battery Life: Two AAA 1.5V,
1200mAh Alkaline.
Could continuously operate for 18 hrs.
5. Dimensions:
Length: 2.19"
(5.5cm)
Width: 1.13"
(2.9cm)
Height: 1"
(2.5cm)
Weight: 1.76oz.
(50g)
(including two AAA batteries)
6. Environment Requirements:
Operation Temperature:
41°F-104°F
(5°C - 40°C)
Storage Temperature:
-13°F to 158°F
Ambient Humidity:
Operation: 15%～93%
no condensation
in operation
Storage: 93% no condensation
in storage/transport
Solution(s)
1. Re-insert/re-position finger
2. Ensure that sensor is clean and not
blocked
3. Try taking a reading on a different finger
or warm your finger by rubbing
1. Re-insert/re-position finger
2. Remain still during measurement
1. Replace batteries
2. Reinstall the batteries
3. Contact warranty center for service
1. Re-insert/re-position finger
2. Replace the batteries
1. Replace batteries
2. Contact warranty center for service
8
(-25°C to 70°C)