Programming The Volume Control Function - THOMSON IFC230 User Manual

Manual programming
This method involves carrying out a manual search for the codes
to be used for controlling your other appliances.
1.
Switch on the appliance you wish to use the remote control
with.
2.
Press the relevant button for this appliance on the remote
control, and while holding this button down, enter one of the
codes relevant to your make of appliance (there is a list of
codes at the end of this manual). If the appliance buttons of the
remote control flash you have entered the wrong code or it is
not possible to program the remote control.
3.
Point the remote control at the appliance and press the
VCR DVD
relevant button ( ,
button. If the appliance does not go into standby mode, try
another code.
Depending on the year of manufacture and the type of appliance,
some functions may not be available. Certain codes may cover
more functions than others.Test the functions you can control and,
if appropriate, try other codes. Note here the code(s) which work
best.
VCR AUX
DVD AMP
SAT
When you change the remote control's batteries, remember
to reprogram it.
Video recorder
Press the VCR button.
On/Standby
MENU To display the main menu
Vertical scrolling in menus
Horizontal scrolling in menus
OK To confirm an action
EXIT To close a menu
0-9 To directly access channels
or enter numeric values
PR+/PR- To change channels
AV To select AV input
REV Rewind
PLAY Play
FWD Fast forward
STOP Stop
PAUSE Pause picture
REC Record
MUTE
+/-
, etc). Press the standby
DVD player
Press the DVD button.
On/Standby
To display the main menu
Vertical scrolling in menus
Horizontal scrolling in menus
To confirm an action
To close a menu
To enter numeric values
or select options in menus
To change chapters
To select AV input
Rewind
Play
Fast forward
Stop
Pause picture

Programming the volume control function

If you have programmed the TV remote control to use with other
appliances and these are connected to an amplifier you can also
programme the remote control to adjust the volume when you
are using one of these appliances.The example below describes
the procedure for programming a DVD player.
1.
AMP
Programme the button on the remote control to use
with the amplifier (refer to page 4).
2.
Move the remote control away from the appliances. Press the
-
button and while holding it down, press the relevant
mode button ( DVD , in this example), then the
-
Release the button.
3.
Switch on the amplifier, then the DVD player.
4.
Set the remote control to
+/-
volume using the
Repeat this operation for the other appliances.
To cancel the programmed function for any of the appliances, press
the - button, while holding it down and enter the code 000
using the numeric buttons.
Satellite receiver
Press the SAT button.
On/Standby
To display the main menu
Vertical scrolling in menus
Horizontal scrolling in menus
To confirm an action
To close a menu
To directly access channels
or enter numeric values
To change channels
Important:
If the batteries in your remote control are run down you can use the
buttons on the front of your TV set. In TV mode, they have the same
functions as the corresponding buttons on the remote control. In the
menus they have the following functions:
PR
PR
VOL OK
or
VOL or OK
MENU To confirm a selection
5
Getting started
AMP button.
DVD
, play a disc and adjust the
buttons.
Hi-fi system
Press the AMP button.
On/Standby
To select a station using
its number
To change stations
To switch the sound off and
back on again
To set the volume level
EN