SCP4020/SCP4420 Series
Series
Sized*
Closer
SCP4020
*
SCP4020 Series are sized door closers wi h 50% power increase capability.
Power size 2 weakest power, power size 6 strongest.
** SCP4420 Series can be adjusted from power size 1 thru 6.
Note: For Special Applications a separate door and frame preparation template is packed with these instructions.
Use this instruction sheet for installation sequence and closer adjustments only.
Arm Stop
Right Hand Door – RH
Left Hand Reverse – LHR
• Security Door Closers only. Door closer cover is handed and cannot be reversed. All other components are non handed.
• It is recommended that the door, on which the door closer will be installed, be hung on ball bearing hinges. Door must swing freely.
• A separate door stop, supplied by others, is recommended to prevent damage to the door closer, closer arm, or to the door, frame or
adjacent walls.
• Door and Frame must be properly reinforced, or use of special fasteners employed, to prevent the mounting screws from pulling out.
• All dimensions are given in inches with corresponding metric dimensions (mm) in parenthesis.
• Torx tamper resistant drive screws are normally supplied with this product.
Installation Instructions
An incorrectly installed or improperly
adjusted door closer can cause
property damage or personal injury.
These instructions should be followed
to avoid the possibility of
misapplication or misadjustment.
Parallel Non Hold Open or Hold Open Arm
For closers with or without "T" suffix Hold Open Control
"T" indicates Thumbturn actuated hold open control.
For closers with or without
Multi-Sized **
Closer
Security Door Closer
(Door Closer with both a Security Cover and Security Arm)
SCP4420
488 Drop Plate is available for doors with narrow top rails.
Push Side Installation
Closer mounts on opposite to hinge (push) side of door.
80-9344-0625-010 (06-09)
"DL"
suffix (Delayed Action) closing feature.
Product Type
t
Holder-Stop
Security Door Closer
Arm Stop
Left Hand Door – LH
Right Hand Reverse – RHR