Operating Elements And Connections - Omnitronic UA-1000 User Manual

4.2 Operating elements and connections

1 BNC jacks
For connecting the pair of antennas of one of the
receivers.
4
BNC jacks
Rear jacks for routing out the the signals of the two
antennas connected to the front jacks. Connect the jacks
to the antenna inputs A and B.
5 Power input with fuse holder
Used to plug the supplied power cord in. Only replace the
fuse when the device is disconnected from mains. Only
use fuses of the same rating and power. The correct fuse
value is specified on the rear panel.
2 Power on/off
3 Power indicator
6 Low-voltage jacks
For supplying power to up to four receivers
7 BNC input jacks
Antenna inputs for the signals of antenna A and B.
8 BNC output jacks
Antenna outputs for splitting the antenna signals A and B
to the antenna inputs of up to four receivers.
20/23 00052269.DOC, Version 1.2