Table Of Contents - IKA MS 3 control Manual

Source language: German
Content
Page
Device setup/Display 2/3
Declaration of conformity 15
Warning symbols 15
Safety instructions 15
Unpack 16
Correct use 16
Commissioning 17
Declaration of conformity
We declare under our sole responsibility that this product corresponds to the re-
gulations 2014/35/EU, 2006/42/EC, 2014/30/EU and 2011/65/EU and conforms
with the standards or standardized documents EN 61010-1, -2-051, EN 61326-1,
EN 60529 and EN ISO 12100.
Warning symbols
Indicates an (extremely) hazardous situation, which, if
DANGER
not avoided, will result in death, serious injury.
Indicates a potentially hazardous situation, which, if not
WARNING
avoided, can result in death, serious injury.
Indicates a potentially hazardous situation, which, if not
CAUTION
avoided, can result in injury.
Indicates practices which, if not avoided, can result in
NOTICE
equipment damage.
Indicates crushing risk of fingers/hand.
CAUTION
EN
Accessories 19
Interface and output 20
Connection, laboratory device - PC 21
Error code 21
Maintenance 22
Technical data 22
Warranty 23
Safety instructions
For your protection
• Read the operating instructions in full before starting up and fol-
low the safety instructions.
• Keep the operating instructions in a place where they can be accessed by
everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health and safety
and accident prevention regulations.
Wear your personal protective equipment in accor-
WARNING
dance with the hazard category of the medium to
be processed. Otherwise there is a risk of:
- splashing liquids
- projectile parts
- body parts, hair, clothing and jewellery getting caught.
• Keep hand/arm vibration to a minimum (Directive 2002/44/EC) when ope-
rated manually:
- Keep the sample container as vertical as possible.
- Only exert the minimum pressure necessary for the mixing process.
- Use attachments for multiple samples when there is a large number of
samples.
• Set up the appliance in a spacious area on an even, stable, clean, non-slip,
dry and fireproof surface.
• The feet of the appliance must be clean and undamaged.
Before starting the device set a low speed.
CAUTION
Gradually increase the speed.
• If the shaking movement of the appliance increases (resonance), reduce the
speed or pass through the critical phase as quickly as possible.
• Reduce the speed if
- the medium splashes out of the vessel because the speed is too high
- the appliance is not running smoothly
- the appliance begins to move around because of dynamic forces.
Caution! Risk of crushing when changing attach-
CAUTION
ments.
15