Wlan Sd Card Firmware Update - Optomed Smartscope PRO User Manual

WLAN SD card firmware update

The WLAN SD card has its own firmware, that can be updated if needed. Follow instructions below to
update the firmware.
Preparations:
1. Download latest FlashAirFWUpdateTool from Toshiba FlashAir support pages.
2. Install FlashAirFWUpdateTool to Windows. After install, UpdateTool is found from Windows start
menu under TOSHIBA.
Update process:
1. Set USB write protection 'Off' from Device menu.
2. Select 'SD card firmware update mode' from Device menu.
3. Place the camera onto the cradle. The camera displays 'SD card firmware update mode' message.
4. Wait for the camera USB drive to get connected to the PC.
5. Start FlashAirFWUpdateTool in PC.
6. Select the camera USB drive as update target and press 'Update'.
7. Wait for UpdateTool progress bar to complete.
8. When UpdateTool asks to remove the card, use Windows 'Safely Remove Hardware' function
from task tray to disconnect the camera USB drive.
9. When UpdateTool asks to insert the card, press any key from the camera to reset the SD card.
10. Do not yet press 'OK' button from UpdateTool. Wait approximately 1 minute while the camera
displays'Programming SD card' message.
11. When the camera shows 'SD card firmware update mode' message again, camera USB drive
should get reconnected.
12. If the camera USB drive is not properly mounted (may take several seconds), repeat from step 9.
13. When the camera USB drive is reconnected to PC, answer OK to UpdateTool query about inserting
the card.
14. Repeat from step 6. (normally will repeat 3 times)
15. When UpdateTool reports 'Updated Successfully', remove Camera from cradle and it will power
off automatically.
16. Update completed.
Page 50 of 51