Adjusting The Height Of Cut - Toro 30672 Operator's Manual

Adjusting the Height of Cut

This machine has a 26 to 108 mm (1 to 4-1/4 inch)
range for the height of cut. Adjust the height of cut by
adjusting the blade spacers, rear axle height, and front
caster spacers. Use the
23) to select the combination of adjustments required.
Adjusting the Blade Height
Adjust the blades by using the 4 spacers on the
blade spindle bolts. This allows for a 25 mm (1-inch)
adjustment range, in 6 mm (1/4 inch) increments, of
cutting height in any axle position. Use the same
number of blade spacers on all blades to achieve a
level cut (2 above and 2 below, 1 above and 3 below,
etc.).
1. Disengage the PTO and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Hold the blade bolt and remove the nut
16).
Height-of-Cut Chart (page
(Figure
1. Blade
2. Blade bolt
3. Curved washer
4. Slide the bolt down through the spindle and
change the spacers as needed
5. Install the bolt and curved washer, add extra
spacer(s), and secure them with a thin washer
and a nut (Figure
6. Torque the blade bolt to 101 to 108 N∙m (75 to
80 ft-lb).
20
Figure 16
4. Spacer
5. Thin washer
6. Nut
(Figure
16).
g001454
16).