Safety; Safe Operating Practices - Toro 30672 Operator's Manual

Safety

Note:
The addition of attachments made by other
manufacturers that do not meet American National
Standards Institute certification cause noncompliance
of this machine.
Improperly using or maintaining the machine can
result in injury. To reduce the potential for injury,
comply with these safety instructions and always
pay attention to the safety alert symbol, which
means Caution, Warning, or Danger—personal
safety instruction. Failure to comply with the
instruction may result in personal injury or death.

Safe Operating Practices

The following instructions are adapted from ANSI
B71.4-2012.
Training
•
Read the Operator's Manual and other training
material. If the operator(s) or mechanic(s) cannot
read or understand the information it is the owner's
responsibility to explain this material to them.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
All operators and mechanics should be trained.
The owner is responsible for training the users.
•
Never let children or untrained people operate or
service the equipment. Local regulations may
restrict the age of the operator.
•
The owner/user can prevent and is responsible
for accidents or injuries occurring to people or
damage to property.
Preparation
•
Evaluate the terrain to determine what accessories
and attachments are needed to properly and
safely perform the job. Use only accessories and
attachments approved by the manufacturer.
•
Wear appropriate clothing; including safety
glasses, long pants, substantial, slip-resistant
footwear, gloves, and hearing protection. Tie back
long hair. Do not wear jewelry.
•
Inspect the area where you will use the equipment
and remove all objects from the area before using
the machine.
•
Use extra care when handling fuels. They are
flammable and its vapors are explosive.
– Use only an approved container.
– Do not remove the fuel cap or add fuel with the
engine running. Allow the engine to cool before
refueling. Do not smoke near the machine
when the engine is running.
– Do not refuel or drain the machine indoors.
•
Check that the operator's presence controls, safety
switches, and shields are attached and functioning
properly. Do not operate the machine unless they
are functioning properly.
Operation
•
Lightning can cause severe injury or death. If
lightning is seen, or thunder is heard in the area,
do not operate the machine; seek shelter.
•
Do not run an engine in an enclosed area.
•
Only operate in well-lit areas, keeping away from
holes and hidden hazards.
•
Ensure that all drives are in neutral and that the
parking brake is engaged before starting engine.
Only start the engine from the operator's position.
•
Make sure that you have good footing while using
this machine, especially when backing up.
Note:
Reduced footing could cause slipping.
•
Slow down and use extra care on hillsides. Be
sure to travel side to side on hillsides. Turf
conditions can affect the stability of the machine.
Use caution while operating near drop-offs.
•
Slow down and use caution when making turns
and when changing directions on slopes.
•
Never raise the deck with the PTO engaged.
•
Never operate with the PTO shield or other guards
not securely in place. Be sure all interlocks are
attached, adjusted properly, and functioning
properly.
•
Never operate with the discharge deflector raised,
removed or altered, unless you are using a grass
catcher.
•
Do not change the engine governor setting or
overspeed the engine.
•
Stop on level ground, disengage drives, engage
the parking brake (if provided), and shut off the
engine before leaving the operator's position for
any reason, including emptying the catchers or
unclogging the chute.
•
Shut off the equipment and inspect the blades
after striking objects or if an abnormal vibration
occurs. Make necessary repairs before resuming
operation.
•
Keep your hands and feet away from the cutting
unit.
•
Look behind and down before backing up to be
sure of a clear path.
•
Never carry passengers on the machine.
4