Stroller Operation - Joovy Kooper X2 Instruction Manual

Installing/Removing the Rear Wheels
• Install a rear wheel by sliding the axle into the hole in the wheel hub until it clicks into place. (5)
Repeat for the other wheel. Pull on the wheels to ensure they are installed properly.
• To remove, push the release button on the rear wheel hub and pull the wheels from the stroller. (6)
5
Installing/Removing the Tray
• Remove the safety caps from the seat mount points by pressing the release button and pulling
each cap off.
• To attach the tray, insert the male fittings on the tray into the female fittings located on both sides
of each seat until it snaps into place. (7) Pull outward on the tray to ensure it is secure.
• To remove, press the buttons located on the underside of both female fittings inward and pull the
tray away from the seat. (8)
• When using the stroller without the tray, always replace the safety caps.
I WARNING:
For use ONLY on the Joovy Kooper X2
Stroller. The tray is not a restraint device. ALWAYS secure your child
with the restraint system. NEVER lift the stroller by the tray. Use caution
when attaching the tray when there is a child seated in the stroller. The
maximum weight that can be carried in each tray is 2 lbs. (0.9 kg).
7
8
6
8

Stroller Operation

Rear Wheel Brakes
• Always engage rear wheel brakes before placing a child in or removing a child from the stroller.
• To engage, push down on the brake lever. (9)
• To release, push down on the back of the brake lever. (10)
NOTE: Gently push the stroller back and forth to ensure the brake is fully engaged.
I WARNING:
Always make sure the wheel brakes are
engaged when the stroller is not being pushed so that the stroller will not
roll away. Never leave stroller unattended, especially on a hill or incline, as
the stroller may tip over or slide.
9
Securing the Seated Child
• There are three height adjustment positions for the shoulder harness. Adjust the height to the
closest height above your child's shoulders.
• To remove the shoulder harness, turn the plastic ends sideways and push them through the slots
in the backrest. Reattach the harness at the proper height by reinserting the plastic ends through
the slots. (11) Ensure both straps are the same height.
• To unlatch the buckle, press the center button and remove the male ends of each side. (12)
• Carefully place the child in the seat with the shoulder straps and pads over their shoulders and
chest. Then place the crotch strap between the child's legs.
• Push the shoulder/waist buckles into the crotch buckle until all parts snap into place. (13)
• Tighten the waist belt to be snug around the child's waist.
• The shoulder, waist, and crotch straps may be adjusted using the sliding plastic rings.
• NEVER allow a child to step onto or sit on the footrest. This may cause the stroller to tip over.
I WARNING:
The seats are not suitable for a child under 3
months. The maximum height of a child the product is designed to carry is
44 in (111.8 cm). The maximum weight of a child the product is designed
to carry is 50 lbs. (22.7 kg) in each seat. Use of the stroller with a child
weighing more than 50 lbs. (22.7 kg), or two children totaling more than
100 lbs (45.4 kg) will cause excessive wear and stress on the stroller and
may cause a hazardous unstable condition. Never leave child unattended.
Avoid serious injury from falling or sliding out. Always use the restraint
system.
10
9