Folding The Stroller - Joovy Caboose Too Ultralight Graphite 817X Manual

Table of Contents

Advertisement

Available languages

Available languages

EN
FR ES JP
• Slide the front fabric pocket, located under the front of the Caboose Rear Seat, over the front of the bench seat. See Figure 18.5. (shows
the underside of the bench seat)
• Locate the 2 long straps on the lower rear of the Caboose Rear Seat (one on each side). Wrap each strap around the outside of the
stroller handle bar and feed them through the loops on the back of the seat. Securely buckle the straps together. See Figure 18.6. If
necessary, pull the webbing near the male end of the buckle to tighten.
• Near the front sides of the Caboose Rear Seat are 2 Velcro® straps (one on each side). Secure these straps around the lower horizontal
frame bar on both sides. See Figure 18.7.
• Wrap the left and right armrests of the Caboose Rear Seat around the upper horizontal frame (on each side). Securely snap together both
snaps on each side. See Figure 18.8.
• Check that the seat is securely in place.
The Caboose Rear Seat is not suitable for children under 6 months. Avoid serious injury from falling or sliding out.
19 Removing the Rear Bench Seat Waist Strap from Stroller
• On the stroller, unsnap both waist straps from the crotch strap on the rear 3-point harness if needed.
• Store the rear bench waist strap into the front seat back pocket or a safe place for future use.
• To completely remove the waist straps, locate one end of the strap where it attaches to the front seat tube. Slide the strap through the
small opening of the metal D-ring and pull the strap away from the front seat. Repeat for the other strap. See Figure 19.1.

20 Folding the Stroller

• Keep children away from stroller while folding.
• Remove any infant car seat. The stroller can be folded with the infant car seat adapter in place.
• Close the canopy and push it forward.
• Put the front seat into the most upright position.
• Make sure both rear wheel brakes are set to their locked positions.
• Lock BOTH front wheel sets in place with locking levers facing forward.
• Unlock the safety latch on the lower left side of the stroller.
• Pull upward on the trigger mechanisms on both sides of the stroller and push the handle fully forward. See Figure 20.1.
CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
• Engage the fold lock on the right side of the stroller over the mounting post. See Figure 20.2.
21 Using the Stroller with an Infant Car Seat (OPTIONAL)
NOTE: See insert for a list of specific compatible car seat models.
• Remove the front tray and install the infant car seat adapter on the same mounts. Ensure it is secure on BOTH sides. See Figure 21.1.
• Push the canopy to its most rearward position.
• ADJUST THE SEAT TO ITS SECOND (MIDDLE) POSITION.
• Remove the infant car seat from its base and place it onto the front seat of the stroller so it is in a REAR FACING POSITION. Position the
"head" end toward the front, resting on the infant car seat adapter. Position the "feet" end on the seatback - but NOT on the top edge of
the seatback. See Figure 21.2.
• Buckle the restraining straps over the LOWEST part of the infant car seat (the straps are located in the pockets on the side of the seat)
Adjust the straps so they are tight around the infant car seat but AWAY from the child's neck. Pull up on the infant car seat to be sure it is
secure. See Figure 21.3.
• To remove the infant car seat from the stroller, unlock the restraining strap buckle by pressing the button and both side releases.
See Figure 21.4.
• Return the restraining straps to their pockets.
ALWAYS install the infant car seat so that the child is facing toward the rear (handle) of the stroller with the
ALWAYS position the infant car seat so that it is securely placed down inside the infant car seat adapter frame.
ALWAYS position the infant car seat so that it is resting ON the seatback, but NOT on the top of the seatback. The
NEVER position the restraining straps on or near the child's neck as this may result in strangulation.
The infant car seat adapter is for use ONLY with specific infant car seat models. See insert for specific models. DO
WARNING
!
Always use the restraint system.
WARNING
!
ALWAYS keep children away from the stroller when folding.
Possible pinching hazard - Be careful when folding the stroller.
WARNING
!
restraining straps secured.
seatback must be in the second (middle) position.
NOT use other infant car seat models.

Advertisement

Table of Contents
loading

Table of Contents