CARE AND MAINTENANCE
•
Wipe the outside of the mills with a slightly dampened cloth.
•
Wipe any excess seasoning from the underside of the grinders with a dry cloth.
•
Do not use the mills over cooking as moisture from the steam can clog the grinding
mechanism.
•
If the seasoning becomes damp and/or the mechanism becomes clogged, completely
empty the grinder, open the grinding knob fully and wash the grinder in warm water.
A mild dishwashing detergent may be used.
•
Allow the grinder to dry completely before refilling and reassembling.
BATTERIES
•
Check that the batteries are fitted correctly - there is a guide inside the battery
compartment.
•
When you need new batteries, change them all. Do not use new and used batteries
together.
•
Ensure that you use the same battery type together i.e. alkaline or heavy duty.
•
Do not leave batteries fitted in the mills if they are not used regularly. The batteries
may leak and damage the mills.
•
Only recharge batteries that are specifically designed to be recharged.
SwITCH
•
Check that the striker panel has not been pushed inwards, towards the motor unit,
during assembly.
NOTE: You may need to raise the striker panel slightly to ensure contact with the button.
LIGHT BULB
•
Check that the bulb connection points and brass connection pins are clean and clear
of any seasoning. Clean with a coarse brush or steel wool, and dust off afterwards.
•
To replace the bulb, tip the whole mill upside down.
•
Grip the bulb and pull it upwards.
NOTE: You may feel some initial resistance - this is normal.
•
Align the wires on the replacement bulb with the contacts inside the bulb socket.
•
Push the bulb downwards into the bulb socket.