Table of Contents
Advertisement
MILK FROTHER
Frothed milk is used in many barista-style coffee drinks like latte, cappuccino, etc. The built-in milk frother aerates the
milk to produce a thick foam making it lighter in texture and increasing its volume.
1. Press the top of the milk frother to release it (Fig. K) then swing the milk frother out.
2. Put the milk into a small jug or something similar and hold it under the milk frother until it is immersed in the milk.
3. Press and hold the button on the top of the milk frother to activate it (Fig. L). Use long presses and make circular
motions with the jug until the desired result is achieved.
Cleaning the milk frother after use
1. Clean the milk frother after every use.
2. Immerse the milk frother in a cup of clean water.
3. Press the button several times to activate it.
4. Repeat several times if necessary.
5. Swivel the milk frother into its compartment and press it until it clicks into place.
•
You can also remove the lower section of the milk frother for cleaning. Twist the shaft to the left and pull it away
from the button section (Fig. M). To replace, fit the shaft over the button section and twist it to the right to lock it.
USING THE TIMER
The timer can be used to make coffee at a predetermined time. The clock needs to be set to the correct time before
you can use the timer function.
1. Prepare your coffee maker as required.
2. Tap the setting L icon.
3. Tap the timer P icon. The display will slowly flash.
4. Turn the select/confirm knob until the time you want your coffee maker to start is displayed. Turning the knob
slowly will increase or decrease the time in 1 minute steps. Turning it quicky will change the time in 15 minute
steps.
5. Press the select/confirm knob G to accept the time.
6. The display will stop flashing and return to show the current time.
7. The Timer icon P will be lit to show that you have set the timer.
8. To cancel the timer at any time, tap the cancel Bicon.
ANTI DRIP
The anti drip lever closes a valve to prevent any drips splashing onto the warming plate when you remove the carafe.
•
Moving the lever to the left will close the valve and the anti drip icon J will be displayed.
•
Moving the lever to the right will open the valve and the icon will go out.
•
If you attempt to brew coffee when the lever is in the closed position, your coffee maker will sound an alert tone
and the icon will flash until you open the valve.
CARE AND MAINTENANCE
Cleaning
1. Unplug the appliance and let it completely cool down.
2. Clean the exterior surfaces with a slightly damp cloth and then dry them thoroughly.
3. Remove the filter and filter holder and empty out the coffee grounds. Wash under running water and dry
thoroughly.
4. Wipe the filter holder compartment with kitchen paper.
5. The bottom cap of the cold brew filter can be removed to assist in cleaning. Twist it clockwise to unlock and
remove. Twist it counterclockwise to lock.
Descaling
After approximately 60 cycles, the cleaning c icon will pulse on and off indicating that the unit should be cleaned/
descaled. This is a warning and will not affect coffee making. You can temporarily cancel the warning by tapping the
cancel Bicon, but to reset the cycle count, you need to run the cleaning function. We recommend descaling your
coffee maker regularly to maintain performance.
Never use a descaling product based on mineral acids such as sulphuric acid, hydrochloric acid, sulphamic acid and
acetic acid (e.g. vinegar). These descalers may damage the machine. Use a descaling product recommended for
appliances with plastic parts.
8
Advertisement
Table of Contents
