Installing The Portacd-Rw Driver Using The Windows Wizard; For Windows 98Se/Me/2000; Figure 30. Add New Hardware Wizard - Teac E24E User Manual

For Windows 98SE/Me/2000

Installing the PortaCD-RW Driver Using the Windows Wizard

This section explains how to install the PCMCIA driver using the Windows
Wizard.
New Hardware
For Windows 98SE/Me/2000
The installation procedure for the PCMCIA Card Driver varies depending on the
version of Windows 98SE/Me/2000 installed in your computer.
To install the driver on a Windows 98SE/Me/2000 system, follow these steps:
1. Insert the PCMCIA card into the PCMCIA card slot in your laptop
computer.
The other end of the card/cable should already be connected to the interface
connector on the PortaCD-RW. (If not, see "Chapter 3. Connecting the
PCMCIA PortaCD-RW to a Windows System" on page 23 for more
information.)
The system displays the initial
Note: The system configuration and your dialog responses determine which panels
the Wizard will display. Do not be concerned if your installation process varies
slightly from the one described below—just follow the dialog instructions.
2. Click the
Next
The system displays the following
(Figure 31 on page 29), asking what you would like Windows to do:
28
Add New Hardware Wizard

Figure 30. Add New Hardware Wizard

button to search for the driver.
Add New Hardware Wizard
TEAC PortaCD-RW User's Manual
Add
panel (Figure 30).
panel