Advertisement
Configuring the CD-RW Drive
Before you can install and operate the TEAC CD-W512S CD-RW drive, you need to
do the following:
Install a SCSI adapter card in the host computer. For optimum performance, a
PCI bus master SCSI adapter card (such as an Adaptec 2940 or equivalent) is
recommended. Please refer to the SCSI adapter card documentation for
installation instructions.
Set the SCSI ID number on the rear panel of the CD-RW drive
Terminate the CD-RW drive if it is located at the end of the SCSI chain.
Setting the SCSI ID Number
To set the SCSI ID number on the CD-RW drive, you must set jumpers on the rear
panel of the unit.
jumper
You set the SCSI ID number for the CD-RW drive by placing jumpers in various
combinations on jumper pin pairs S0, S1, and S2. ("S" indicates a jumper pin pair
number.) The following table indicates the appropriate pin combinations. "Close"
indicates that you should place a jumper on the specified jumper pins. "Open"
indicates that you should not place a jumper on the specified pins (leaving the
connection "open"). For example, to set the CD-Recorder to SCSI ID 5, you would
place jumpers on jumper pin pairs S0 and S2.
The factory default setting is SCSI ID 3 (S0 and S1 closed).
SCSI
0
ID
0
Open
1
Close
2
Open
3
Close
4
Open
5
Close
6
Open
7
Close
TEAC CD-RW Installation Guide
jumper pins
1
2
Open
Open
Open
Open
Close
Open
Close
Open
"S" numbers
Open
Close
Open
Close
Close
Close
Close
Close
SCSI ID
Parity Switch
jumper pin configuration block
4
Setting the SCSI ID Number
Termination
Factory
use only.
Advertisement
