Displaying The Screen - Eizo DuraVision FDX1501 Setup Manual

Displaying the Screen

1.
Press to turn on the monitor.
The monitor's power indicator lights up blue.
2.
Turn on the PC.
The screen image appears.
If an image does not appear, refer to "No picture" (page 8) for additional advice.
If using the FDX1501T proceed with installation and calibration of the touch panel driver.
Attention
• Turn off the monitor and PC after using them.
• For the maximum power saving, it is recommended that the Power button be turned off. Turning off the main power
switch or unplugging the power plug completely shuts off power supply to the monitor.
Installing the Touch Panel Driver (FDX1501T)
Attention
• The user account to be used for installing the touch panel driver must have the "Administrators" privilege.
• When reinstalling the touch panel driver to update the driver, etc., restart the PC after uninstalling the driver and then
install it.
1.
Uninstall the other touch panel driver, if it is installed.
2.
Install the touch panel driver according to the instructions included in the CD-
ROM.
For how to install the touch panel driver, see the Touch Panel Driver User's Manual (on the CD-ROM).
3.
Use the USB cable (MD-C93) to connect the monitor and the PC.
Connectors
on the monitor
4.
Restart the PC.
Calibrating the Monitor (FDX1501T)
Calibrate the monitor according to the Touch Panel Driver User's Manual (on the CD-ROM).
USB Cable MD-C93 (supplied)
Connectors
on the PC
USB
7