Table of Contents
Advertisement
Tools
* The adjusting/setting function on the <Color> menu depend on the selected Color mode(page
23) The above table shows the sub menus when the "Custom" mode is selected (See "3-3.
Color Adjustment"(page 23))
3-2. Displaying Screen Correctly
Digital Input
When digital signals are input, images are displayed correctly based on the preset data of the
monitor. When performing advanced adjustment, see "3-3 Color Adjustment" (page 23) and
subsequent pages.
Analog Input
Note
•
Wait 30 minutes or more from monitor power on before starting adjustments.
(Allow the monitor to warm up for at least 30 minutes before making adjustments.)
The monitor screen adjustment is used to suppress flickering of the screen or adjust screen
position and screen size correctly according to the PC to be used.
The auto adjustment function works when filling/satisfying all of the following conditions
•
When a signal is input into the monitor for the first time or when the resolution or Vertical/
Horizontal Frequency not displayed before is set
•
When signals with the vertical resolution over 480 are input
If the screen is not displayed correctly even after performing the auto adjustment, perform
the screen adjustments according to the procedures on the following pages to use the monitor
comfortably.
Input Selection
Mode Preset
Signal Info
Monitor Info
All Reset
Chapter 3 Adjustment and Settings
"5-2. Connecting More than Two
PCs to the Monitor"(page 37)
"3-5. Enabling/Disabling Mode
Selection"(page 29)
Displaying signal information
Displaying monitor information
"3-11. Restoring the Default
Setting"(page 32)
1
Advertisement
Table of Contents
