Advertisement
QUICK-START INSTALLATION GUIDE
Surface Layer Configuration
Layers are useful when you need to access a number of DSP input channels on your engine which is
larger than the number of faders (or phisical channel strips) available on your Quasar surface.
Since any fader on any module could access any input channel on the Quasar Engine, every Fader
module will need to be configured to access the correct input channel, for each of the four layers
available.
1. Using a PC connected to your studio network, launch a web browser and enter the IP address
assigned to the first (leftmost) fader module into the browser's address bar. When prompted for
authentication enter user name "user", and leave the password field blank.
2. In the left column, in the Module Manager section of the menu, select Layer Setup
Enter the number of the Engine input channel you want to assign to each physical fader, for each of the
four Layers.
The table shown in the picture shows which input channel, of the 64 available in the Quasar Engine,
will be loaded on the four channel strips each time the LAYER 1, 2, 3, 4 buttons will be pushed on the
Master Touchscreen module.
Advertisement
