Advertisement
QUICK-START INSTALLATION GUIDE
Below you can associate your Quasar Engine to the surface, by entering the Engine's IP address.
Addresses can be entered directly from the touchscreen, or by using the rotary encoders below the
display. A configured gateway is optional, and not required for normal console operation in a closed
network.
Press the "Save and Reboot" button when done.
Once the Master Module IP address is set, you can now access the console Web UI to configure each fader
module's IP address.
Quasar Surface – Modules' discovery & configuration
Using a PC connected to your studio network, launch a web browser and enter the IP address you
previously assigned to the MTS into the browser's address bar. When prompted for authentication enter
user name "user", and leave the password field blank.
In the left column, click on Console Discovery menu. There you will find all Fader modules connected to
the Master, listed by their MAC and IP addresses, which will be pre-assigned at the factory. If the pre-
assigned addresses fits your networking scheme, then you can skip to the next step.
In case you need to change these addresses according to your network scheme, you can assign a new IP
address to each module, by selecting it with the radio button, entering the desired address in the box at
the bottom and pushing the "Do It!" button.
Advertisement
