Advertisement
QUICK-START INSTALLATION GUIDE
Assign Sources to Input Channels
Once all the required Sources are created, you need to assign them to the input channels of your Quasar
Engine, and save this configuration in what we call "Show Profile".
You can do so in two ways:
1. Assigning Sources directly from the console, and capturing your configuration into a Show
2. Creating a Show Profile from the Web UI and assigning sources to your channels from within
this page
From The Console:
Push the top encoder of the channel strip you want to load with a source, and select the Source tab in
the Master Touchscreen module.
Here you will be presented with a list of all the sources that have been configured on your console, and
are active onto the network, and you will be able to select one by scrolling the touchscreen and pushing
the Load Source button on the right.
Note:
Inactive sources – those
generated by devices
which are disconnected
from the network, or
switched off – will not
be detected by the
Quasar and therefore
will not show up on the
above list.
Advertisement
