Download Print this page
MASCOT 9640 12V Instructions For Use

MASCOT 9640 12V Instructions For Use

Three-step charger

Advertisement

Quick Links

Manufacturer I Fabricant I Hersteller I Constructeur:
MASCOT ELECTRONIC
Norway I Norvege I Nowegen I Noorwegen
Read instructions carefully
Read the following instructions carefully. In case of damages due to failure to comply
with instructions, the guarantee will be invalid. We will not be liable for resulting
damages.
A lire absolument
Liser ce mode d'emploi attentivement. Toutes autre ou mauvaise utilisation que
Unbedingt lesen
Lesen Sie diese Anleitung genau durch. Bei Schaden, die durch Nichtbeachtung der
Anleitung verursacht werden, erlischt der Garantieanspruch. Fur Folgeschlden
Absoluut te lezen
Lees deze handleiding aandachtig door. In geval van schade die voortvloeit uit het niet
naleven van de instructies in deze handleiding, vervalt de garantie. Wij zijn evenmin
aansprakelijk voor vervolgschade.

Advertisement

loading
Need help?

Need help?

Do you have a question about the 9640 12V and is the answer not in the manual?

Questions and answers

Summary of Contents for MASCOT 9640 12V

  • Page 1 Manufacturer I Fabricant I Hersteller I Constructeur: Absoluut te lezen Lees deze handleiding aandachtig door. In geval van schade die voortvloeit uit het niet MASCOT ELECTRONIC naleven van de instructies in deze handleiding, vervalt de garantie. Wij zijn evenmin aansprakelijk voor vervolgschade.
  • Page 2 This charging unit is designed to charge lead acid accu-packs with a rated voltage of 12V. The storage battery meets the safety regulations EN 603362-29:96 and may only be The accumulators must be suitable for a charging current of 2,7A. Dependent on the connected to alternating voltage mains of 230V.
  • Page 3 When working with charged components, only tools which are specifically designed for LED Display such purpose may be used. The three-coloured LED display installed in the charging device signals the following Should the situation arise that safe use of the device is no longer possible, it must be placed operations:- ‘out of order’...
  • Page 4 Take note of the polarity and connect the correct conductor leads of the charger to the corresponding terminal of the accumulator. This means, connect the positive terminal (+) of the charging unit (red wire) to the positive terminal (+) of the accumulator and the negative terminal (-) of the charging unit to the negative terminal (-) of the accumulator If loading an accumulator which is already fitted in the vehicle, connect the accu terminal (connected to vehicle chassis) to the chassis of the charger last.