Stihl BT 360 Instruction Manual page 21

:
Thread the new starter rope (see
"Specifications") through the top of
the grip and the rope bush (9).
: Pull the rope through the rotor
secure it with a simple overhand
knot.
:
Push the the rotor onto the starter
post – turn it back and forth until the
rewind spring anchor loop engages.
BT 360
3
5
6
:
Refit the pawl (6) in the rope rotor.
: Fit the washer (5) on the starter
post.
:
Use a screwdriver or suitable pliers
to fit the spring clip (3) on the starter
post and over the guide peg on the
pawl – the spring clip must point
clockwise, as shown in the
illustration.
Tensioning the rewind spring
:
Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
:
Hold the rotor steady – straighten
the twisted rope – release the rotor.
:
Let go of rope slowly so that it winds
onto the rotor.
:
The starter grip must be firmly
seated in the rope guide bush.
If the grip droops to one side: Add
one more turn on rope rotor to
increase spring tension.
English
21