Stihl BT 360 Instruction Manual page 14

English
When engine begins to fire:
:
Push in the choke knob and
continue cranking.
As soon as the engine runs:
:
Immediately move the throttle lever
back to the idle position – the engine
will settle down to idling speed.
Make sure the carburetor is
correctly adjusted – the drilling
spindle must not rotate when the
engine is idling.
The machine is now ready for operation.
14
2
To shut down the engine:
:
Move the stop switch (2) to "STOP"
At very low outside temperatures:
Allow engine to warm up.
If engine doesn't start:
If you did not push in the choke knob
quickly enough after the engine began to
fire, the combustion chamber is flooded.
: Pull off the spark plug boot.
:
Unscrew and dry off the spark plug.
: Set the stop switch to "STOP".
: Crank the engine several times with
the starter to clear the combustion
chamber.
:
Refit the spark plug and connect the
spark plug boot,
:
Move the stop switch away from
"STOP".
:
Push in the choke knob – even if the
engine is cold.
:
Now start the engine.
If fuel tank has been run until dry and
then refueled:
:
Pull the starter rope several times to
prime the fuel system.
BT 360