Metronome - Tascam D00871320A Owner's Manual

Point editing
Even when the screen shows positions in bars and beats,
location points are edited in minutes and seconds ("To edit a location
mark" on page 29), except that the bars and beats equivalent is also
shown.
When the key is held down in "bars and beats" mode, the dis-
LOCATE
play looks something like this:
Selecting a point to edit shows the bars and beats below the absolute
time value. The bars and beats cannot be set directly, but change,
together with the absolute time value, as the jog wheel is turned:

Metronome

To help you keep in time, the DP-01 provides an internal metronome
function and a MIDI metronome function. The internal metronome
function allows you to listen to the metronome on the DP-01, while
the MIDI metronome function generates a metronome output on the
MIDI interface.
1
Press , use the
MENU
cursor key.
2
Select the
METRONOME
When "INT" is selected at "Output" [internal metronome]
The DP 01's internal metronome (not an external sound source) can be out
put to headphones and LINE OUTPUT L/R.
Mode
Select from
RecOnly
and playback).
IntLvl
Set the output level of the metronome within the range 0 to 127.
(The output level cannot be adjusted on the MASTER fader.)
When "MIDI" is selected at "Output" [MIDI metronome]
This setting generates a metronome output via the MIDI interface. Gener
ally, percussion type sounds are used as the metronome. Any sound, of
course, can be produced.
dial to select the
DATA MIDI
item, and press the
(only at recording) and
Rec&Play
Advanced techniques
menu, and press the
cursor key.
(at recording
TASCAM DP-01 Owner's Manual
IN, OUT and TO
points do not show
the bars/beats value when being
edited.
The internal metro-
nome is not output
in the following instances:
• While the BOUNCE key is lit
• While the MASTER key is flashing
or is lit
37