Use The Router As A Dhcp Server - TP-Link HC220-G1 User Manual

Chapter 8
4. Enter a new IP Address
5. Select the Subnet Mask
the IP address identifies the local IP subnet.
6. Keep the rest settings as default.
7. Click OK to make the settings effective.
8. 4. 2.

Use the Router as a DHCP Server

You can configure your Controller to act as a DHCP server to assign IP addresses to
its clients. To use the DHCP server function of the Controller, you must configure all
computers on the LAN to obtain an IP Address automatically.
Follow the steps below to configure DHCP server.
1. Visit http://tplinkwifi.net, and log in with the password you set for the Controller.
2. Go to Settings >
3. Select IPv4 and click the edit icon in the
4. Enable DHCP function and select
5. Specify the IP Address
same subnet with LAN IP. The router will assign addresses within this specified
range to its clients. It is from 192.168.23.100 to 192.168.23.199 by default.
appropriate to your needs.
from the drop-down list. The subnet mask together with
Advanced Settings
DHCP
Pool, the start address and end address must be on the
> DHCP Server.
Modify column.
Server.
Customize Your Network
49