IMPORTANT SAFETY PRECAUTIONS
This product has been designed and manufactured
according to FDA regulations "title 21, CFR, chapter
1, subchapter J, based on the Radiation Control for
Health and Safety Act of 1968", and is classified as
a class 1 laser product. There is no hazardous invis-
ible laser radiation during operation because invisible
laser radiation emitted inside of this product is com-
pletely confined in the protective housings.
The label required in this regulation is shown at 1.
DO NOT REMOVE THE PROTECTIVE HOUSING
USING A SCREWDRIVER.
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
I F T H I S P R O D U C T D E V E LO P S T R O U B L E ,
CONTACT YOUR NEAREST QUALIFIED SERVICE
PERSONNEL, AND DO NOT USE THE PRODUCT
IN ITS DAMAGED STATE.
: SANYO Electric Co., Ltd.
: Less than 0.25 mW on the objective lens
: 760 to 820 nm
Rack-mounting the unit
If you are mounting the unit in a rack, leave 1U of
space above it and 4 inch (10cm) or more of space at
Use the rack-mounting kit to mount the unit in a stan-
dard 19-inch equipment rack, as shown in this sec-
tion. Remove the feet of the unit before mounting.