Table of Contents
Advertisement
BASIC OPERATIONS
Online Playback and Monitor Playback
The CD player has two playback modes, online playback
and monitor playback. The output destination in each of
these playback modes can be set individually.
For example, in sites such as broadcasts and events,
the monitor playback mode can be used to cue tracks or
playback points before the final take, and then the CD
player can be set to online standby (READY), and online
playback can be performed from that point at the time of the
final take.
On this CD player, the UNBALANCED analog output
terminal and SPDIF digital output terminal are positioned
as terminals for monitor output, and the BALANCED analog
output terminal and AES/EBU digital output terminal are
positioned as terminals for online output.
Note, however, that in the default setting both the monitor
playback signal and the online playback signal are output in
the same way from all analog/digital output terminals.
B y c h a n g i n g t h e m e n u s e t u p , y o u c a n s e t t h e
UNBALANCED analog output terminal and SPDIF digital
output terminal for monitor exclusive output, or the
BALANCED analog output terminal and the AES/EBU
digital output terminal for online exclusive output. (→ page
22 "Setting the Terminals for Online Output") (→ page 22
"Setting the Terminals for Monitor Output")
[NOTE]
•
This manual refers to the online playback standby state
as "online READY" and the monitor playback standby
state as "monitor PAUSE."
Preparations
1 Turn the POWER switch on the rear panel to ON.
When the Remote Control Unit RC-601MKII (sold
separately) is used, connect the unit with the CD
player turned OFF.
2 Press the OPEN/CLOSE key to open the disc tray.
3 Load the disc in the tray with the label face up.
4 Press the OPEN/CLOSE key to close the disc tray.
The total number of tracks on the disc and total playing
time will be displayed on the display window.
[NOTE]
•
Instead of pressing the OPEN/CLOSE key, you can
also close the disc tray by pressing the PLAY/PAUSE,
READY or TRACK keys.
12
TASCAM CD-601MKII
Selecting the Playback Mode
You can select the playback mode by using the PLAY
MODE key.
Each press of this key switches the playback mode in the
following order:
Regular playback (all tunes) → single playback →
program playback
The current playback mode is displayed in the
playback mode display area of the display window.
Playback Mode
Display Window
Regular playback
(nothing displayed) Tunes are played
Single playback
SINGLE lit
Program playback PROGRAM lit
The selected playback mode is backed up on the
CD player. So, the same mode is reproduced when
the CD player is next turned ON.
Operation
back in disc track
o r d e r . ( r e g u l a r
playback)
Only the selected
t r a c k i s p l a y e d
back.
Tunes are played
back in the preset
program order.
Advertisement
Table of Contents
