Download Print this page
SOMFY inteo CENTRALIS RTS Installation Manual

SOMFY inteo CENTRALIS RTS Installation Manual

Advertisement

Quick Links

INSTALLATION
1
Characteristics:
UP button
Intermediate position / STOP
button
DOWN button
2
Installation:
A
MOUNTING THE CENTRALIS RTS
1. Screw the plate on the wall.
inteo
The CENTRALIS RTS is a wireless control compatible with all the RTS receivers.
Commands are transmitted by radio (frequency 433.42 MHz) over a range of 300
meters in free space, and at least 20 meters even if it has to pass through two rein-
forced concrete walls.
LED
80 mm
CENTRALIS RTS
80 mm
2. Clip the Centralis RTS to the plate.
guide
Power: 3V lithium battery, CR 2430 type
Protection index: IP 30
Operating temperature: +5°C to +40°C
Class III product
Normally polluted environment
0165
Hereby, SOMFY, declares that this equipment is in
17 mm
compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.
A Declaration of Conformity is available at the web
address www.somfy.com Heading CE
Recommendations :
Do not install the CENTRALIS RTS near or
against a metallic part.
minimum distance between the CENTRALIS
RTS and the RTS receiver : 30 cm.
®

Advertisement

loading
Need help?

Need help?

Do you have a question about the inteo CENTRALIS RTS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SOMFY inteo CENTRALIS RTS

  • Page 1: Installation Guide

    Class III product button Normally polluted environment DOWN button 0165 Hereby, SOMFY, declares that this equipment is in 17 mm compliance with the essential requirements and 80 mm other relevant provisions of Directive 1999/5/EC. A Declaration of Conformity is available at the web address www.somfy.com Heading CE...
  • Page 2: Initial Installation

    Programming INITIAL INSTALLATION SINGLE CONTROL • Set the RTS receiver in its programming mode (refer to the installation guide of the concerned RTS receiver). • Press shortly the programming button on the backside of the CENTRALIS RTS The RTS receiver emits a signal (LED or Buzzer depending on the type of receiver) indi- cating that the address of the CENTRALIS RTS has been memorized in the RTS receiver which automatically quit its programming mode.