Delay Cycle; Sterilisation Cycle; Panel Commands - VWR VAPOUR-Line lite Instruction Manual

Delay cycle

1) Press 'ENTER' until the 'dELY' parameter is shown on lower display.
2) Select the delay time using the arrows. The delay time will be shown on the upper display.
3) Press 'ENTER' to save to memory.

Sterilisation cycle

1) Press the 'START/STOP' button for 3 seconds to start the cycle.
The following indicators will be shown:
a) Flashing LED until the selected sterilisation temperature is reached on lower display
b) Vessel actual temperature on upper display
c) Programmed temperature on lower display
d) 'HEATING' LED on, during heating time
e) 'AUTOCONTROL' LED on for automatic control of selected parameters
2) When the sterilisation temperature has been reached, the time left to reach end of the cycle is
shown on the lower display.
3) The end of the sterilisation cycle is indicated by an acoustic alarm for ten seconds. The 'CYCLE
END' LED will light up for ten seconds.
4) The upper display will show the actual vessel temperature; the lower display will show the word
'OFF'.
5) At the end of vessel cooling, open the lid to take out the sterilised material.

Panel commands

START/STOP
▼▲
ENTER
GREEN LED
CYCLE END LED
HEATING LED
AUTOCONTROL LED
To start/stop the programme
Arrows selection
Multifunctional button:
- To memorise selected
parameters
- To switch from one function to
another
- To control the selected
programme
Flashes until selected
temperature has been reached
On at the end of the sterilisation
cycle for ten seconds
On during heating time
On to indicate that the automatic
8