Cleaning, Maintenance - GE eBike with Control Terminal PC Operator's Manual

7

Cleaning, Maintenance

7.1 Cleaning, Disinfection
Equipment Surface
Warning
Shock Hazard – Before cleaning the device,
disconnect it from the power line.
Equipment Damage – Liquids must not be allowed
to enter the device. Devices into which liquids have
entered must be immediately cleaned and checked
by a service technician, before they can be reused.
Do not use acids or alkaline solution (household
cleaners) or caustic disinfectants. We recommend
Fugaten spray, Lysoform or Promanum N for
disinfection.
Wipe the device surface down with a cloth moistened
with soap water or a disinfectant. The cloth must not
be dripping wet; liquids must not enter the device.
Blood-Pressure Cuff
Clean the blood-pressure cuff by wiping it down with
a cloth moistened with soap water. Take care that no
liquids enter the bladder of the cuff.
Alcohol is the only approved disinfectant.
Regularly clean the microphone; to do so, remove it
from its pocket in the cuff. Note the microphone
orientation so as to be able to reinsert it correctly after
cleaning (brass-colored side towards artery).
Clean the microphone with a cloth moistened with
alcohol or soap water. Dry the microphone before
reinserting it in the cuff.
Cables
Disconnect cables from the device before cleaning
them.
Use a cloth moistened with soap water to wipe the
cables clean. Do not immerse the cable in liquid.
26
Cleaning, Maintenance
7.2 Maintenance
Checks before each use
Before each use visually check the device and the
cables for signs of mechanical damage.
If you detect damage or impaired functions that may
result in a hazard to the patient or the operator, the device
must be repaired before it can be used again.
Technical Safety Inspections, Inspections of
the Measuring System
The technical safety inspections and the inspections of
the measuring system must be completed every two years
according to the rules of the art by a Service Engineer
authorized by GE Medical Systems Information
Technologies.
Similarly, the automatic sphygmomanometer in the
control terminal must be checked and calibrated by an
authorized specialist every two years to fulfill legal
requirements.
The date of the next inspection is indicated on the
inspection sticker attached next to the nameplate on the
ergometer.
Ergometer Adjustment
For a description, please refer to the Service Manual
available on request from GE Medical Systems
Information Technologies.
Disposal of the Product —
At the end of their service life, the product described
in this manual and its accessories must be disposed
of in compliance with the applicable local waste
control regulations. If you have questions about
the disposal of the product, please contact GE
Medical Systems Information Technologies or a
representative.
eBike with Control Terminal PC
Caution
2018112-001 Revision B