Replacing Filters - Shark DuoClean IC160UK Series Instructions Manual

Cordless upright with powered lift-away
Hide thumbs Also See for DuoClean IC160UK Series:
Table of Contents

Advertisement

MAINTENANCE
Your vacuum comes equipped with three filters located on the vacuum pod: two pre-motor filters (one is a
filter frame) and one HEPA filter to capture and trap dust and debris.
CLEANING PRE-MOTOR FILTER (ONCE A MONTH)
Perform regular maintenance on your filters to keep your vacuum's suction power optimal.
IMPORTANT: To prevent damage, rinse filters with lukewarm water ONLY. DO NOT use soap. Allow filters
to air-dry for at least 24 hours before replacing them in the vacuum to prevent liquid from being drawn into
electric parts.
Foam
Filter
Filter
Frame
9
0800 862 0453
Filter
Door
1. Slide down filter door release button.
2. Tilt filter door and lift off.
3. Remove filter from pod. Pull off foam filter.
4. Rinse foam filter and filter frame with lukewarm
water ONLY and leave to air-dry for at least
24 hours before reinstalling.
5. Once completely dry, reinsert foam filter on
filter frame.
6. Holding the pull tabs, push the filter back
into the pod.
7. Reinsert bottom of filter door into slots on
pod. Tilt door to close, pressing until it clicks
into place.
MAINTENANCE
CLEANING HEPA FILTER (ONCE A YEAR)
Perform maintenance on your HEPA filter once a year to keep your vacuum's suction power optimal.
IMPORTANT: Rinse HEPA Filter with lukewarm water ONLY. DO NOT use soap. Allow to air-dry for at least
24 hours before reinstalling. DO NOT scrub HEPA Filter.
HEPA
Filter

REPLACING FILTERS

Follow the previous instructions for removing filters. The Foam Filter should be replaced every
2.5 years, and the HEPA Filter should be replaced every 3 years, subject to frequency of use.
Replacement Pre-Motor Filter
and Frame
NOTE: To order replacement parts and filters, visit sharkclean.eu.
1. Pull up on HEPA Filter access tab to remove.
2. Rinse filter with lukewarm water ONLY and leave
to air-dry at least 24 hours before reinstalling.
3. When dry, reinsert HEPA Filter and press down
until it clicks into place.
Note: Battery must be removed before HEPA Filter
can be removed.
Replacement HEPA Filter
s h a r kc l e a n . e u
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents