Shark DuoClean IC160UK Series Instructions Manual page 4

CHARGE INDICATOR LIGHTS
In Use: Lights illuminate steadily
Full
Charge
TOP OF BATTERY
Low
Charge Indicator
Charge
Light
TEMPERATURE ISSUE: FIRST AND THIRD INDICATOR LIGHTS FLASHING ALTERNATELY
If the first and third indicator lights are flashing alternately, the battery
temperature is not optimal. If this happens when charging, leave the battery
plugged in and charging will resume once temperature reaches optimal level.
NOTE: The battery must be charged before first use. A complete charge takes approximately 3.5 hours.
NOTE: The indicator light will shut off 5 minutes after reaching full charge.
OPERATING THE VACUUM
POWER BUTTON SURFACE
Press Power button. Select surface setting:
Carpet
For thick pile carpets.
Floor
For hard floors
and rugs.
IMPORTANT: Your unit will default to Max Power when using in Lift-Away mode.
M ax Power shortens runtime.
NOTE: Select Carpet mode for stuck-on dust and debris.
5 0800 862 0453
Mid Low
Charge Charge
Charging: One light flashes
Mid Nearly
Charge Full
SETTINGS
SUCTION LEVEL
Press icon to boost power:
BOOST
When in Lift-Away®
mode, press BOOST
icon to turn on or off.
The default power setting
on floors and carpets is
extended runtime. For an
additional boost of suction
power, press and hold the
BOOST icon.
Needs
MODE AND SETTINGS
Charge
UPRIGHT & POWERED LIFT-AWAY®
(CARPET)
UPRIGHT & POWERED LIFT-AWAY
(FLOOR)
Full
ABOVE FLOOR & LIFT-AWAY
Charge
(WAND OR HANDLE)
POD, HANDLE AND WAND ARE DETACHABLE
DETACH THE POD
Press LIFT-AWAY button on
handle and lift pod off floor
nozzle.
DETACH THE WAND
Press the Wand Release button
until it clicks, then pull up on wand
to detach from the floor nozzle.
OPERATING THE VACUUM
RUNTIMES
REGULAR BOOST POWER
Up to 30 minutes
Up to 30 minutes Up to 20 minutes
Up to 50 minutes
TIP: See next page for all the different
ways you can use your vacuum.
DETACH THE HANDLE
Pull the Handle Release trigger to
detach the handle from the wand.
s h a r kc l e a n . e u 6