Introduction - Raven SCS 700 Installation & Service Manual

INTRODUCTION

The Raven SCS 700 (PRODUCT INJECTION SYSTEM) is designed to improve the accuracy and
uniformity of spray applications. Its performance relies on the installation and preventive maintenance of
the complete sprayer. It is important that this Installation and Service Manual be reviewed thoroughly before
operating the system. This Manual provides a simple step-by-step procedure for installing and operating
the system.
The SCS 700 consists of a computer based Control Console, a Speed Sensor, one or two Injection Modules
(each includes a Motor Control and Metering Pump with sensors), an In-Line mixer, and cables. The
Console mounts directly in the cab of the vehicle for easy operator use. The Radar Speed Sensor is
mounted to the frame of the vehicle or implement (Wheel Drive and Speedometer Drive Speed Sensors
are also available). The Injection Module mounts to the framework of the sprayer. The In-Line Mixer mounts
just before the Boom On/Off Valves. Appropriate cabling is furnished for field installation.
The operator sets the target application rate for each product to be sprayed and the SCS 700 automatically
maintains the flow regardless of vehicle speed or gear selection. A manual override switch allows the
operator to manually control flow for each product for spot spraying. Actual volume per area being applied
is displayed at all times for both products. The SCS 700 additionally functions as an area monitor, speed
monitor, and volume totalizer.
TYPICAL SYSTEM (WITH CARRIER) DIAGRAM:
The diagram shown below is a typical SCS 700 system. It is suggested that the SCS 700 console be
installed to use Product 1 as the carrier, and Product 2 for injection or auxiliary. Although this is not required,
it is the recommended system.
4