Table of Contents
Advertisement
Depressing this key after selecting BOOM CAL selects the last boom number.
EXAMPLE: b-02 will decrease to b-01.
Entering the calculated Boom Cal data:
a)
Select desired boom number.
b)
Enter boom length as determined in section "CALCULATING BOOM CAL".
c)
If a boom is not needed or used, enter a "0" for the length.
10)
Enter SPEED CAL in
11)
Enter METER 1 CAL calibration number in
12)
Enter METER 2 CAL calibration number in the
13)
Enter VALVE 1 CAL calibration number in
14)
Enter VALVE 2 CAL calibration number in
15)
Enter PROD 1 CAL Target Application Rate
NOTE:
16)
Enter PROD 2 CAL Target Application Rate, in
perform the following two steps to complete the INITIAL CONSOLE PROGRAMMING:
a)
Enter "1.0" for PROD 2 CAL.
b)
Re-enter "0" for PROD 2 CAL.
YOU HAVE NOW COMPLETED REQUIRED PROGRAMMING FOR THE CONSOLE
17)
The flashing "CAL" should now extinguish. If not, repeat the programming procedures starting at
Step 9.
2.
OTHER DISPLAY FEATURES
1)
To display TOTAL AREA covered, momentarily depress
enter a "0" in this key.
.
A decimal point is automatically shown in the display window. Therefore, 20
ounces per acre is entered as "2""0""0", but shown as "20.0".
.
. If only one product is being used, enter "0".
.
. If only one product is being used, enter "0".
.
. If only one product is being used, you must
. To "zero out" this total at any time,
17
Advertisement
Table of Contents
