Permissions - TANDBERG 6000 MXP Profile User Manual

4.1.7

Permissions

Permissions contains settings for incoming MCU Calls, incoming telephone Calls, Far End
Control, Remote Software Upgrade and Fallback to Telephony.
Access Code
An access code will help you control the use of the system. All users must enter a code to identify
themselves and the call will be charged on their account. Access Codes are handy for group
systems where there are more users or divisions that share the costs of using the system. Access
Code can be set to "On" and "Off". Please refer to section
Access codes.
On
When making a call, an Access Code dialog box will be shown. The user must enter
the correct password in order to put the call through.
Off No password is necessary to make a call.
Incoming MCU Calls
On When you are in a call, the system will provide visual and audible indications of an
incoming call and ask you to accept/reject the call.
Off The system will not accept incoming calls when you are in a call.
Incoming Telephone Calls
On The system will accept incoming telephone calls.
Off The system will not accept incoming telephone calls. This is useful to prevent
incoming calls from systems other than videoconferencing systems.
Far End Camera Control
On The far end will be able to:
• Control your camera
• Select your video sources
• Activate your camera presets
• Request snapshots
Off
The far end can access none of the four features above on the local system. You will
however still be able to control the camera on the far end.
Administrator Settings
Appendix 5 for more information on
127