Table of Contents
Advertisement
Basic Operating Principles
Shutdown and Restart
No System Response?
The Content Server will always be turned on and be
available to record conference calls.
The physical unit should not be accessible to users.
If the system does not respond:
•
Check the LCD panel to determine if the unit is
switched on and 'live'
•
Make sure that the Content Server is switched on by
using the On/Off switch located at the rear of the unit
•
Restart the Content Server using the LCD panel.
or,
•
Restart the TCS service on the Content Server (this
will only affect the calls which are live at the time of
the restart, but will not affect any users accessing
recorded content on the server).
How to use the front panel keys is explained on the
next page.
Command Menu Structure
IP Settings
are treated in
Installation.
Restart?
No
Yes
IP Settings
Commands
Shutdown?
No
Yes
Restoring Factory
- Restore Factory -
Settings is described on
Full Restore
the next page.
Config Restore
Table of
What's New in
Trademark/
Contents
this Version?
Licenses
D 13898.04
DECEMBER 2006
Restarting the Content Server
1.
Press
Enter
to display the Main Menu screen
From the Main Menu screen, use the
.
to select Commands
Press
Enter
to confirm your selection
.
.
From the Commands menu, use the
to select Restart and press
.
You will be asked to confirm this action on the following
screen. At the Restart? prompt, use the
arrow to select Yes and press
For an overview of the Command Menu Structure – see
below left.
For details on how to restart the TCS service
without restarting the Content Server, see the
Administrator Settings
Full Restore?
No
Yes
Config Restore?
No
Yes
Safety/
Introduction
Installation
Environmental
1.
Press
Up
or
Down
arrow
.
From the Main Menu screen, use the
Commands
.
Press Enter to confirm your selection
Up
Down
From the Commands menu, use the
or
arrow
.
Enter
Shutdown and press
.
You will be asked to confirm this action on the following screen. At the
Up
or
Down
Shutdown? prompt, use the
Enter
to confirm.
press
For an overview of the Command Menu Structure – see below left.
section.
safe to shutdown within a few minutes.
!
Do Not Shutdown or Restart While Calls Are In Progress!
We do not recommend to shutdown or restart the Content Server while calls are in progress. If the
Content Server is in a call and the server is restarted or shut down, calls in progress will fail and
will not be recorded.
The LCD panel display indicates the current status of the Content Server.
<IP Address>
IN CALL
<IP Address>
NOT IN CALL
Quick Setup
Operation
TANDBERG
Shutting Down the Content Server
Enter
to display the Main Menu screen
Up
or Down arrow to select
Up
or
Down
Enter
Up
or
Down
arrow to select Yes and
Enter
to confirm.
There is currently no indication on the LCD panel to tell the
administrator that the machine has shut down and that it is safe
to turn off the server. Typically the server is in a state that it is
LCD panel display when a call is currently in progress.
LCD panel display when no calls are currently in progress.
Administrator
Conference
View
Settings
Setup
Conferences
CONTENT SERVER
USER GUIDE
arrow to select
Appendices
Advertisement
Table of Contents
