Table of Contents
Advertisement
TANDBERG Content Server User Manual
3 General Use
TANDBERG Content Server
The Content Server will always be turned on and be available to record conference calls.
The unit itself should not be available to users at anytime.
If the system does not respond:
Check the LCD panel to determine if the unit is switched on and 'live'.
Make sure that the Content Server is switched on by using the On/Off switch located at
the rear of the unit.
Restart the Content Server using the LCD panel. For details, see section 3.1, Restart and
shutdown.
or,
Restart the H.323 service on the Content Server (this will only affect the calls which are
live at the time of the restart, but will not affect any users accessing recorded content on
the server). For details on how to restart the H.323 service without restarting the Content
Server, see the Administrator Settings chapter.
3.1 Restart and shutdown
The server can be restarted and shutdown via the LCD panel.
NOTE:
It is not recommended to shutdown or restart the Content Server while calls
are in progress. If THE CONTENT SERVER is in a call and the server is
restarted or shutdown, calls in progress will fail and will not be recorded.
The LCD panel display indicates the current status of the Content Server.
<IP Address>
IN CALL
<IP Address>
NOT IN CALL
10
LCD panel display when a call is currently in progress.
LCD panel display when no calls are currently in progress.
Advertisement
Table of Contents
