ABB C505 User Manual page 79

...4.8.6 Relay Outputs 1 to 4
•1
C. . 2 3
rL4. A
•4
NONE
•2
C. 2 4
rL4. P
•3
POS
LEVC
ASSN
•1 If the output is assigned to a control output by the control type, the setting displayed cannot be changed – see
Section 4.2, Basic Configuration/ Control Output Type.
•2 Not displayed if relay is assigned to a control output signal.
•3 Not applicable if relay is assigned to a control output.
•4 Only displayed if relay ouput is fitted.
Relay 4 Assignment Source
Select the source required to activate relay output 4
See Rear Fold-out/ Table C – Digital Sources.
Relay 4 Polarity
•4
The relay can be set to energize for either an active or inactive digital
signal.
POS – Relay energized when source is active.
– Relay energized when source is inactive.
NEG
Return to top of page.
4 CONFIGURATION MODE...
C23...C24
75