ABB C505 User Manual page 4

GETTING STARTED
The COMMANDER 500 can be configured and made ready for operation in three easy
steps. This 'Getting Started' guide provides an overview of these steps and, where
necessary, refers to the relevant section of the manual.
Step 1 – Decide on the Application Template and the
Output Configuration required
Step 2 – Connect the process inputs and outputs
Step 3 – Power up the instrument, set the template number and the output
configuration details
Your COMMANDER 500 is now ready for operation
Step 1 – Application Template and Output Configuration
• Choose the Template which best suits your application from the list in Table A,
located on the rear fold-out.
• Choose the Control Output Type required from the list of options in Table B on the
rear foldout.
Step 2 – Electrical Connections
Using the labels on the back of the instrument as a guide, connect the process inputs,
outputs and power supplies. Refer to Section 5.2 of this manual (Electrical Installation)
for more information.
Continued...