Table of Contents
Advertisement
GETTING STARTED
Step 3 – Setting the Parameters (Fig. GS.1)
Power-up the instrument. Press the
A
3 seconds to advance directly to Level 6 – Basic Configuration.
Set the appropriate application template, output type and control action. Use the
B
key to advance between frames and upper
default values – see Section 4.2 for further information.
Note. When the output type has been selected, the available inputs and outputs
default to the settings shown in Table B on the rear fold-out.
If you are not using 4 to 20mA inputs, then select Level 7 using the upper
C
keys and set up Analog Inputs I/P1 to I/P3 to suit your process – see Section 4.3.
D
Controller templates only:
Select Level 2 using the upper
• Analog or Motorized Valve Control – set the Proportional, Integral and
Derivative terms.
• Time Proportioning Control – set the Cycle Time, Hysteresis and P, I & D Terms
• Heat/Cool Outputs – set the points at which the Output 1 and Output 2
become active.
E
Press
to return to the Operating displays.
Adjust the set point to the required value.
F
A
50. 1
+
50. 5
50
Your COMMANDER 500 is now in operation
LEV. 6
LEV. 7
APPL
INPt
B
t. A PP
01. S L
O. t YP
ANLG
C. A Ct
rEV
FrEJ
50
Fig. GS.1 Setting the Parameters
and
keys simultaneously and hold for
and
keys and set the tune parameters:
LEV2
tUNE
C
D
50. 1
50. 5
50
and
keys to adjust the
F
E
Note.
With
above
configuration,
no alarms or limits
have been set and
advanced functionality
(gain scheduling, set
point sources etc.) has
not been enabled.
and
50. 1
50. 5
50
the
Advertisement
Table of Contents
