ABB C505 User Manual page 66

...4 CONFIGURATION MODE
...4.5 Level 9 – Set Point Configuration
•1
9. 1 2
Lr. 5 r
NONE
•1
9. 1 3
LC. 5 r
NONE
•1
9. 1 4
r. S rC
NONE
LEV9
SEt. P
•1 Digital inputs are active when a volt-free contact is closed or a low TTL signal is applied.
62
Local/Remote Set Point (or Ratio) Selection Source
The source required to lock into remote set point mode or remote ratio
mode when the ratio controller template is selected.
When the source is active the
See Rear Fold-out/
Table C – Digital Sources.
Local Set Point (or Ratio) Selection Source
The source required to select local set point mode or remote ratio mode
when the ratio controller template is selected.
See Rear Fold-out/
Table C – Digital Sources.
Remote Set Point (or Ratio) Selection Source
The source required to select remote set point mode or remote ratio mode
when the ratio controller template is selected.
See Rear Fold-out/
Table C – Digital Sources.
Return to top of page.
key does not operate.
L L R
Remote
Local
Local Set Point Mode
Remote Set Point Mode
9.12...9.14
•1
Local
•1
•1