Handlebar Switches - Yamaha Super Tenere ABS XT1200ZE Owner's Manual

Handlebar switches

Left
2
1
6
5
4
1. Menu switch "MENU"
2. Select switch " /
3. Cruise control switches
4. Horn switch " "
5. Turn signal switch "
6. Dimmer/Pass switch "
Right
2
3
1. Stop/Run/Start switch "
2. Drive mode switch "MODE"
3. Hazard switch " "
Dimmer/Pass switch "
Set this switch to "
beam and to " " for the low beam.
To flash the high beam, push the pass
side "PASS" of the switch while the
headlights are on low beam.
Instrument and control functions
EAU1234M
3
"
/ "
/ /PASS"
1
/ / "
EAU54201
/ /PASS"
" for the high
3-23
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
the switch down towards "
page 5-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12461
/ "
". When
EAU12501
"
EAU54212
/ / "
", and then push
". See
" to stop the en-
EAU12735
" posi-
ECA10062
3