Installation Of The Remote Unit On The Remote Stand - Sony PCM-3348HR Installation Manual

1-4. Installing the Remote Control Unit on the Remote Stand
1-4-2. Installation of the Remote Unit on the
Remote Stand
Procedure
(1) Attach the remote control unit to the remote stand top
plate, paying attention to the mounting positions
shown in instructions 1 and 2 below.
1 Align the rear panel of the remote unit with the rear
end of the remote stand top plate.
Top plate
2 Adjust the position of the remote unit so that it is
located in the center of the remote stand top plate.
Check that the right and left rear feet of the remote
unit are located in the center of the ring-shaped hole of
the remote stand top plate.
1-6
(2) Temporarily secure the remote unit to the top plate
from the bottom of the top plate with four +PSW4 x
16 screws. (When the screws cannot be inserted into
the holes, slide the remote unit slightly backward and
forward or right and left to adjust the position.) When
all the four screws has been inserted in the holes,
fasten them securely.
Rear panel
Rear end
(3) Secure the remote cable connecting the remote unit to
the recorder with the cord clamp located at the bottom
of the top plate.
Top plate
Remote cable
Top plate
+PSW4 x 14
(4pcs)
Cord clamper
2 Lock.
1 Insert the
remote
cable.
PCM-3348HR