Bosch NDP-7512-Z30C Installation Manual page 21

AUTODOME IP starlight 7000i
Figure 7.2: Interface Box Connections
After routing all video, control, power, and alarm wires:
1.
2.
3.
1.
2.
3.
Connecting Alarm Inputs and Outputs
4
4
Connector
Alarm Out Connector [P102]
Bosch Security Systems
Attach a 3/4-inch NPT (20-mm) conduit fitting to the hole in which you bring in the wires.
Be sure to thread the inside nut to the conduit fitting.
Route the video, control, power, and alarm wires through the conduit fitting and into the
Interface Box.
Cut and trim the wires allowing for sufficient slack to their respective terminals in the
box.
Attach the remaining control data in/out wires to their respective terminals in the
Interface Box.
Connect the Ethernet cable to its mating connector J101 in the Interface Box.
Connect the 24 VAC power wires to the P101 connector in the Interface Box.
To connect alarm inputs and outputs, attach the supplied 6-pin Alarms In and the 4-pin
Alarms Out connector plugs with flying lead wires to the appropriate incoming alarm
wires. Alarm Out 4 is a relay.
Connect the plugs to their mating connectors P103 and P102 in the Interface Box.
Pin Label Description
1 OUT1 Alarm Out 1
2 OUT2 Alarm Out 2
3 OUT3 Alarm Out 3
4 AGND Alarm ground
Installation Manual
Installing the In-Ceiling Mount | en
Wire Color
White
Brown
Orange
Green
2019-09 | 0.8 |
21