Advertisement
All manuals and user guides at all-guides.com
Important - UK only
The wires in the cord are coloured
G
as follows:
Blue = Neutral
Brown = Live.
The appliance must be protected by
G
a 13A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
G
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
G
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
key
blender
filler cap
lid
goblet
blender sealing ring
blender blade unit
base
speed + pulse control
pre-programmed buttons
power unit
cord storage
mill (if supplied)
mill jar
mill sealing ring
mill blade unit
mill base
mill lid
to use your blender
1 Fit the sealing ring
blade unit
marked
the seal is located correctly in the
grooved area.
Leaking will occur if the seal
G
is damaged or incorrectly
fitted.
2 Clip the blade unit
.
3 Screw the blade assembly onto the
goblet – ensuring the blade
assembly is fully tightened.
4 Put your ingredients into the goblet.
Never blend more than 1.6
litres or more than 1 litre for
frothy liquids like milkshakes.
5 Fit the filler cap to the lid.
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the power
unit.
The appliance won't work if
G
the blender is incorrectly
fitted.
8 Plug in and the 4 pre-program
buttons will light up.
9 Choose one of the following options:
Select one of the 4 pre-programmed
G
buttons (refer to the function selector
chart). When the required program
button is pressed the lights on the
other 3 buttons will go out. The
blender will switch off automatically
at the end of the pre-set time. If you
wish to stop before the pre-set time,
press the selected program button
again.
Select speed 1 (low) to 5 (High) by
G
turning the speed control. At the end
of blending return the speed control
to "0" before removing the blender.
(P) Pulse – operates the motor in a
G
start/stop action. The pulse will
operate for as long as it is held in
position.
3
to the blender
– ensuring
into the base
Advertisement
