Dmx Connection - Evolite HYBRID 17R User Manual

Always secure your fixture with a safety cable!
o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.
Main Menu
DMX address: setting up the DMX address
Channel mode: set the channel mode, and the number of the menu options to represent the number of channels.
Run: set the run mode.
Test 1 (factory test): running program set by the manufacturer, which is mainly used for factory testing.
Test 2 (Gobo): the program set by the manufacturer, which is used to display the rotation Gobo and prism.
Test 3 (color): the program set by the manufacturer, which is used to display the static Gobo, prism and color
effect.
MUSIC: do the corresponding movement according to the outside sound intensity and intensity change. The
relevant parameters can be set in [operation settings] - [sound control settings].
PROG: running a user self-programming. The playback scene or edit scene can be set in the two menus of the
[run settings] - [mixed scene] and [scene editing].
Reset operation: Reset Motor
Motor power off: Choose "yes", all motor power off; choose "no", all motor re-power and reset. Using
this menu, the motor can be plugged and reset without turning off the light.
Pan/Tilt: reset Pan and Tilt motor
Color: reset color wheel
Gobo: reset the fixed Gobo wheel
Dimming: reset dimming
Zoom / prism, such as re-positioning and zoom, focusing, 16 prism, 24 prism, and frost mirror.
Hybrid 17R Manual Ver. 1.00 Page 20