Dmx Connection; Set Up; Control Panel - Evolite 52931 User Manual

o DMX 512 Connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or
properly. Please note the starting address depends upon which controller is being used. Only use a
DMX cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or
one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried
out in compliance with IEC standards.
 Set up

Control panel

o
The control board offer several features. You can simple set the starting address, run the pre-
programmed program or make a reset
The main menu is accessed by pressing the Mode/Esc-button, Browse through the submenu by
pressing Up or Down .Press the Enter-button in order to select the desired menu. You can change
the selection by pressing Up or Down, Confirm every selection by pressing the Enter-button. You
can leave every mode by pressing the Mode/Esc-button .The functions provided are described in
the following setting.
d001 001-512 DMX mode and set address
MAFA FASt Master auto mode in fast
MStS Master sound mode
MStc Stand-alone mode
SlAu Slave mode
MASL-SLOU Master Auto mode in slowly
PAn PAn/rPAn Pan reverse
MOVING WASH 3x20C Manual Ver. 1.02 Page 13